5003 Sıva Art SSatin Plaster

5003

It is a white cement based, one component, non-cracking, water and moisture resistant plastering material that completely eliminates surface defects on the topcoat, can be used before painting, indoors, on walls and ceilings, has high adherence and durability compared to gypsum and gypsum based materials, reduces paint consumption.

► White Cement Based
► Applicable with Trowel
► Water and Moisture Resistant
► High Adhesion Strength
► Saves Time and Labor
► Low Consumption

> White
> Public Works Pos No: 04.476/D

• Used indoors and outdoors, on black surfaces, on walls and ceilings to smooth surfaces before painting.

• Provides aesthetic appearance.
• Prepares the surface for painting.
• As it provides high adherence with the surface, does not spill, bond strength is high.
• High performance, does not crack.
• Easy to prepare and apply.

a) Surface Preparation:
Before applying 5003 Sıva Art S, cement based plaster should be applied on the surface. The surface should be dry, clean, sound and free of dust, oil, dirt or adhesion preventive materials should be cleaned from the surface and materials such as mortar and cement residues should be scraped. Application surface should be moistened with water if necessary. After the surface cleaning, the surface should be primed with Termatect primer as a single layer to increase the adhesion strength and balance the surface absorbency and should be allowed to dry for 1-2 hours.

b) Product Preparation:
20 kg 5003 Sıva Art S (White) is slowly added into approximately 6.5 - 7.5 liters of clean water and mixed with a low speed mixer until no lumps remain. The prepared mortar is rested for 5-10 minutes to mature and mixed again for 1-2 minutes. The mixture in the container should be consumed within 2-3 hours.

c) Application Method:
Application should be performed on all surfaces with equal thickness with the help of steel trowel. After the plaster is discharged its water, the surface should be clovered and the final corrections should be made with a damp sponge. If a smooth surface cannot be obtained when completely dry, sanding should be applied where necessary. Application thickness should be between 1-3 mm in one coat. Application Recommendations: After application, the surface should be moistened for 2-3 days. After the full drying time, sanding should be done. It should not be applied on surfaces where paint, ready colored plaster, rough rendering or siding has been applied.

Contact...

You can contact us to get more detailed information about our products.

“ We will continue to seek superior quality and superior service with the power we receive from you. ”

Terma Construction Chemicals
San. Tic. Ltd. Şti.