8001-01 Terma Floor QQuartz Surface Hardener

8001

It is a abrasion resistant, powder surface hardener which is applied monolithically to fresh concrete surfaces, consisting of special type cement, high quality quartz aggregate and performance enhancing chemical additives. Used against light and medium loads.

► Cement Based, Quartz Aggregate
► High Adhesion Strength
► Indoors and Outdoors
► Suitable for Heavy Pedestrian Traffic
► Easy To Apply
► Low Consumption

> Natural Grey / Red / Green
> Public Works Pos No:

• Suitable for industrial floors with light to medium traffic. For example;
• In basement floors and cellars,
• In mechanical workshops,
• In garages for passenger cars,
• In warehouses,
• In corridors and large halls,
• In the fields of education,
• In parking areas,
• On loading and unloading areas with rubber wheeled vehicle traffic.

• High abrasion resistance (2 times more than normal concrete surface),
• Low pore structure due to its compact structure,
• Interesting,
• Easy clean and maintain,
• Different color options,
• Limited dust formation,
• Resistance to mineral oils and petroleum derivatives.

a) Surface Preparation:
If 8001 Terma Floor Q is to be applied on old concrete, at least 7.5 cm thick C 25 concrete must be poured. Use Epoxy Surface Primer or Latex to increase adherence and adhesion between new concrete and old concrete. The concrete to be applied must be wet enough to absorb the moisture that 8001 Terma Floor Q needs. The degree of wetness of the surface is extremely important. If the surface is too wet, 8001 Terma Floor Q will disappear within the thickness of the concrete itself and become ineffective. If the surface is too dry, the product will not bind to the surface and the result will be negative.

b) Application Method:
Depending on the size of the floor, 4 - 5 m wide anos are placed as one full and one empty. Where necessary, mesh steel is placed in the anodes and the leveling process is completed. 8001 Terma Floor Q should be spread on both sides of the anos in order to get the best distribution on the surface. Concrete is gauged after casting, and it is ensured that it is settled with vibrating gauge application. When the concrete is set up with a foot, the footprint remains at a depth of 2-3 mm at most, and 1/2 of 8001 Terma Floor Q is spread evenly by hand or by mechanical spreading machine. It is expected that the material will absorb the water of the concrete, moisten and get a dark color. Make sure the color is equal on all sides of the floor. With trowel, material is fed to the ground thoroughly and integration is provided. A quantity of material is sprinkled onto the edges of the ano and dilatation joints, which are under the highest load, in a strip of 8 cm and fed with a trowel. The remaining 1/2 of the material is spread by sprinkling on the ground, it is expected to get a dark color by moistening and fed to the ground with a trowel. When the surface is hard enough to walk, polishing1 is performed with steel trowel (helicopter).

c) Hardening:
After application, Termatect Curing agent should be used for curing of concrete.

d) Joint Cutting:
After the concrete is poured, joint cutting should be done within 2-3 days at the latest. After placing Termatect Polyethylene Joint Sealant into the joint gaps, the remaining gaps should be filled with the appropriate MS, hybrid or polyurethane mastics of Termatect.

Contact...

You can contact us to get more detailed information about our products.

“ We will continue to seek superior quality and superior service with the power we receive from you. ”

Terma Construction Chemicals
San. Tic. Ltd. Şti.