7001-03 Tamir Art CRStructural Repair Mortar

7002

It is used in interior and exterior of all buildings especially in under ground, ground surface and underwater floors where sulfate and chlorine resistance is desired; chamfering application, repair surface correction before waterproofing or final coating; repair of concrete and reinforcements which damaged due to abrasion of reinforcing irons. It is fine/thick structural repair mortar.

► Cement Based
► Indoors and Outdoors
► High Adhesion Strength
► Water and Frost Resistant
► Easy To Apply
► Low Consumption

> Grey
> Public Works Pos No: 04.613/3A

• It is used in conjunction with adhesion promoter primer in interior and exterior of all buildings especially in under ground, ground surface and underwater floors where sulfate and chlorine resistance is desired, chamfering application, repair, surface correction before waterproofing or final coating, repair of concrete and reinforcements which damaged due to abrasion of reinforcing irons, it gives excellent results especially in chamfering, filling of rod holes and drilling cores.

• Due to its high compressive strength, it provides effective results in structural repairs.
• It is used in structural repair of all kinds of reinforced concrete structural elements.
• Very high adhesion strength.
• It forms a durable and smooth surface after application.
• Does not contain sulphate and chloride ions.
• Resistant to water and frost.
• Easy to prepare and apply.

a) Surface Preparation:
The surface should be dry, clean, sound and free of dust, oil, dirt or adhesion preventive materials should be cleaned from the surface and materials such as mortar and cement residues should be scraped. After the surface cleaning, the surface should be primed with Termatect primer as a single layer to increase the adhesion strength and balance the surface absorbency and should be allowed to dry for 1-2 hours. In order to increase the adhesion strength before application on exposed concrete surfaces, the surface should be primed with Termatect exposed concrete primer as a single layer and allowed to dry for a minimum of 3 hours. Reinforcing Irons; If there is rust on the iron reinforcement, it should be cleaned. Adherence Primer should be applied with a brush as two coats on the iron reinforcement and 7001-03 Tamir Art CR Structural should be applied on the primer before it dries.

b) Product Preparation:
25 kg 7001-03 Tamir Art CR, is poured slowly into 5 - 6 liters of clean water and preferably mixed until homogeneous mixture is obtained. The mixture should be made with a low speed mixer (less than 500 rpm). Any additives not specified in the application instructions should not be added.

c) Application Method:
7001-03 Tamir Art CR should be applied on all surfaces to be repaired with equal thickness using a steel trowel. After application, the surface should be polished with a damp sponge or trowel.

Contact...

You can contact us to get more detailed information about our products.

“ We will continue to seek superior quality and superior service with the power we receive from you. ”

Terma Construction Chemicals
San. Tic. Ltd. Şti.