• Ready to use.
• Is applied with a brush.
• Not affected by sunlight, UV resistant.
• Maintains elasticity even at low temperatures.
• Provides high adherence.
• Easy and fast to apply.
• Resistant to freeze-thaw cycle.
• Paintable.

a) Surface Preparation:
The application surface must be solid, dry, carrier, dust-free and clean and at the same time in balance. The surface should be thoroughly cleaned of any oil, grease, rust and paraffin residues that may weaken the adherence and there should be no loose particles on the surface. Appropriate Termatect Repair Mortars should be used on unlevel surfaces. New plastered and reinforced concrete surfaces should be waited to complete the curing period of 28 days. Corners and edges should be chamfered with a 4 cm diameter with Termatect Sealant Mortar or Termatect Structural Repair Mortar. Surface gaps can be repaired with Termatect Sealant Mortar or Termatect Structural Repair Mortar. The flow of water towards the outlet must be ensured. Deep cracks should be filled with joint sealant.

b) Product Preparation:
3005 Prolikit Plus UV is a ready-to-use material. In the primer application, 50% water is added to 3005 Prolikit Plus UV and mixed with 400-600 rpm mixer for 3-5 minutes. In the first coat application, 20% water should be added and mixed with a mixer of 400-600 rpm for 3-5 minutes. Second coat should be applied without mixing with water.

c) Application Method:
The prepared primer should be applied to the surface with a brush or roller (200 gr/m²). After the primer has dried, the other coats should be applied to form a wet film thickness of 1 -1,50 mm. Cracks, joints, corners and edges should be supported with the appropriate waterproofing net after the first coat application.

d) Coloring:
3005 Prolikit Plus UV is produced in white color. It can be colored with pastry pigment at a rate not exceeding 5% of the amount of material. 3005 Prolikit Plus UV can be painted with acrylic based exterior paint after drying.